GATE 2020 ME Set 2 · Question 59
Water (density ) flows through an inclined pipe of uniform diameter. The velocity, pressure and elevation at section are , and , respectively, and those at section are , and , respectively. If acceleration due to gravity is then the head lost due to friction is *(round off to one decimal place)*.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.49 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
Applying the energy equation between sections and :
where is the total piezometric plus velocity head, and is the head loss due to friction.
The total head at section is:
The total head at section is:
Since , the velocity heads cancel out directly:
Answer: 8.0
Practise Flow through pipes
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flow through pipes
- GATE 2017 ME Set 1 · Q8Water (density = 1000 kg/m3) at ambient temperature flows through a horizontal pipe of uniform cross section…
- GATE 2017 ME Set 1 · Q31Consider steady flow of an incompressible fluid through two long and straight pipes of diameters d1 and d2…
- GATE 2015 ME Set 1 · Q16Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming the mass…
- GATE 2015 ME Set 3 · Q32Three parallel pipes connected at the two ends have flow-rates Q1, Q2 and Q3 respectively, and the…
- GATE 2012 ME · Q5Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m.…
- GATE 2024 ME · Q37In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.