GATE 2024 ME · Question 37
In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have the same friction factor. The pipes connecting points , , and with point have an equal length . The pipe connecting points and has a length . The pressures at the ends , , and are equal. The flow rate in the pipe connecting and is . Assume that the fluid flow is steady, incompressible, and the pressure losses at the pipe entrance and junction are negligible. Consider the following statements:
I : The flow rate in pipe connecting and is .
II: The pressure difference between and is equal to the pressure difference between and .
Which one of the following options is CORRECT?
- A
I is True and II is False
- B
I is False and II is True
- C
Both I and II are True
- D
Both I and II are False
GATE 2024 · Mechanical Engineering · IISc Bangalore
Answer
From the official answer key published by IISc Bangalore.
Worked solution
Let be the static pressure at the junction , and be the pressures at the respective exits. We are given that .
Statement II:
The pressure differences are:
Thus, , which makes Statement II True.
Statement I:
Using the Darcy-Weisbach equation for head loss in pipes of identical diameter and friction factor :
Since :
By conservation of mass at junction :
Thus, Statement I is False (it would only be if the flow were laminar where , but here Darcy's law with constant indicates turbulent flow ).
Answer: (B) I is False and II is True
Practise Flow through pipes
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flow through pipes
- GATE 2020 ME Set 2 · Q59Water (density 1000 kg/m3) flows through an inclined pipe of uniform diameter. The velocity, pressure and…
- GATE 2017 ME Set 1 · Q8Water (density = 1000 kg/m3) at ambient temperature flows through a horizontal pipe of uniform cross section…
- GATE 2017 ME Set 1 · Q31Consider steady flow of an incompressible fluid through two long and straight pipes of diameters d1 and d2…
- GATE 2015 ME Set 1 · Q16Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming the mass…
- GATE 2015 ME Set 3 · Q32Three parallel pipes connected at the two ends have flow-rates Q1, Q2 and Q3 respectively, and the…
- GATE 2012 ME · Q5Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m.…
Question from the official GATE 2024 ME paper, IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.