GATE 2017 ME Set 1 · Question 31
Consider steady flow of an incompressible fluid through two long and straight pipes of diameters and arranged in series. Both pipes are of equal length and the flow is turbulent in both pipes. The friction factor for turbulent flow though pipes is of the form, , where and are known positive constants and is the Reynolds number. Neglecting minor losses, the ratio of the frictional pressure drop in pipe 1 to that in pipe 2, , is given by
- A
- B
- C
- D
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For two pipes connected in series carrying an incompressible fluid, the volumetric flow rate is constant (). The mean flow velocity is:
The Reynolds number is:
Given the friction factor :
By Darcy-Weisbach equation, the frictional pressure drop is:
Substituting :
Therefore, the ratio of pressure drops is:
Answer: (A)
Practise Flow through pipes
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flow through pipes
- GATE 2015 ME Set 1 · Q16Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming the mass…
- GATE 2015 ME Set 3 · Q32Three parallel pipes connected at the two ends have flow-rates Q1, Q2 and Q3 respectively, and the…
- GATE 2012 ME · Q5Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m.…
- GATE 2024 ME · Q37In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have…
- GATE 2020 ME Set 2 · Q59Water (density 1000 kg/m3) flows through an inclined pipe of uniform diameter. The velocity, pressure and…
- GATE 2017 ME Set 1 · Q8Water (density = 1000 kg/m3) at ambient temperature flows through a horizontal pipe of uniform cross section…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.