GATE 2015 ME Set 3 · Question 11
For the given fluctuating fatigue load, the values of stress amplitude and stress ratio are respectively
- A
and
- B
and
- C
and
- D
and
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
From the fluctuating stress cycle, the maximum stress is and the minimum stress is .
The stress amplitude (alternating stress) is defined as half of the stress range:
The stress ratio is defined as the ratio of minimum stress to maximum stress:
Options with incorrectly use the reciprocal ratio , and those with incorrectly take the peak stress as the amplitude.
Answer: (C) and
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2014 ME Set 2 · Q20In a structure subjected to fatigue loading, the minimum and maximum stresses developed in a cycle are 200…
- GATE 2014 ME Set 3 · Q16A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum…
- GATE 2013 ME · Q40A bar is subjected to fluctuating tensile load from 20 kN to 100 kN. The material has yield strength of 240…
- GATE 2025 ME · Q43The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of…
- GATE 2024 ME · Q26Which one of the following failure theories is the most conservative design approach against fatigue failure?
- GATE 2023 ME · Q18The S-N curve from a fatigue test for steel is shown. Which one of the options gives the endurance limit?
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.