GATE 2016 ME Set 1 · Question 60
The tool life equation for HSS tool is . The tool life () of is obtained using the following cutting conditions:
, ,
If speed (), feed () and depth of cut () are increased individually by , the tool life (in min) is
- A
0.15
- B
1.06
- C
22. 50
- D
30.0
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.50 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The extended Taylor tool life equation is:
When cutting speed , feed , and depth of cut are each increased by , the new parameters become:
Equating the constants for initial and new conditions:
Dividing through by :
Rearranging for :
Given :
Thus, option (B) is correct.
Answer: (B) 1.06
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2016 ME Set 3 · Q61In a single point turning operation with cemented carbide tool and steel work piece, it is found that the…
- GATE 2015 ME Set 1 · Q33Under certain cutting conditions, doubling the cutting speed reduces the tool life to (1/16 )th of the…
- GATE 2014 ME Set 3 · Q33Cutting tool is much harder than the workpiece. Yet the tool wears out during the tool-work interaction,…
- GATE 2013 ME · Q34Two cutting tools are being compared for a machining operation. The tool life equations are: aligned Carbide…
- GATE 2026 ME · Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200 RPM. If the…
- GATE 2024 ME · Q60A cutting tool provides a tool life of 60 minutes while machining with the cutting speed of 60 m/min. When…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.