GATE 2016 ME Set 1 · Question 61
A cylindrical job with diameter of and height of is to be cast using modulus method of riser design. Assume that the bottom surface of cylindrical riser does not contribute as cooling surface. If the diameter of the riser is equal to its height, then the height of the riser (in mm) is
- A
- B
- C
- D
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.51 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
According to the modulus method of riser design, the modulus of the riser () must be at least times the modulus of the casting ():
For the cylindrical casting with diameter and height :
Hence, the required modulus of the riser is:
For the cylindrical riser with diameter and height , where the bottom surface does not contribute to cooling:
Equating :
Answer: (A)
Practise Casting: Patterns, Moulds, Gating and Solidification
34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Casting: Patterns, Moulds, Gating and Solidification
- GATE 2016 ME Set 2 · Q59Gray cast iron blocks of size 100 mm × 50 mm × 10 mm with a central spherical cavity of diameter 4 mm are…
- GATE 2016 ME Set 3 · Q31Equal amounts of a liquid metal at the same temperature are poured into three moulds made of steel, copper…
- GATE 2015 ME Set 1 · Q46The solidification time of a casting is proportional to (V/A )2, where V is the volume of the casting and A…
- GATE 2015 ME Set 2 · Q58A cube and a sphere made of cast iron (each of volume 1000 cm3) were cast under identical conditions. The…
- GATE 2015 ME Set 3 · Q17In full mould (cavity-less) casting process, the pattern is made of
- GATE 2015 ME Set 3 · Q42Ratio of solidification time of a cylindrical casting (height = radius) to that of a cubic casting of side…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.