GATE 2016 ME Set 2 · Question 35
In an ultrasonic machining (USM) process, the material removal rate (MRR) is plotted as a function of the feed force of the USM tool. With increasing feed force, the MRR exhibits the following behavior:
- A
increases linearly
- B
decreases linearly
- C
does not change
- D
first increases and then decreases
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.25 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
In Ultrasonic Machining (USM), the feed force (static load) pushes the vibrating tool against the abrasive slurry and workpiece.
- At low feed forces, increasing the force increases the impact energy transferred from the tool to the abrasive grains, thereby increasing the Material Removal Rate (MRR).
- Beyond an optimum feed force, the excessive force dampens the vibration amplitude of the horn/tool and restricts the replenishment and circulation of fresh abrasive slurry in the machining zone. Furthermore, abrasive grains may fracture prematurely under excessive force.
Consequently, the MRR first increases with increasing feed force until reaching a peak value, and then decreases as the force is increased further.
Answer: (D) first increases and then decreases
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2016 ME Set 2 · Q62The surface irregularities of electrodes used in an electrochemical machining (ECM) process are 3 μm and 6…
- GATE 2016 ME Set 3 · Q32In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that
- GATE 2015 ME Set 2 · Q31The primary mechanism of material removal in electrochemical machining (ECM) is
- GATE 2015 ME Set 2 · Q63A resistance-capacitance relaxation circuit is used in an electrical discharge machining process. The…
- GATE 2014 ME Set 2 · Q33The following four unconventional machining processes are available in a shop floor. The most appropriate…
- GATE 2014 ME Set 3 · Q28The process utilizing mainly thermal energy for removing material is
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.