GATE 2017 ME Set 1 · Question 44
A horizontal bar, fixed at one end (), has a length of , and cross-sectional area of . Its elastic modulus varies along its length as given by , where is the length coordinate (in ) along the axis of the bar. An axial tensile load of is applied at the free end (). The axial displacement of the free end is _______ .
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The total axial elongation of a bar of length with constant axial load and cross-sectional area , but varying modulus of elasticity , is given by:
Given data:
Substituting these into the integral:
Converting to millimeters:
Answer: 1.718
Practise Simple Stress, Strain and Elastic Constants
22 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Simple Stress, Strain and Elastic Constants
- GATE 2017 ME Set 2 · Q50A rod of length 20 mm is stretched to make a rod of length 40 mm. Subsequently, it is compressed to make a…
- GATE 2016 ME Set 1 · Q42A horizontal bar with a constant cross-section is subjected to loading as shown in the figure. The Young's…
- GATE 2016 ME Set 2 · Q33The value of true strain produced in compressing a cylinder to half its original length is
- GATE 2016 ME Set 3 · Q30Engineering strain of a mild steel sample is recorded as 0.100%. The true strain is
- GATE 2016 ME Set 3 · Q43A square plate of dimension L × L is subjected to a uniform pressure load p = 250 MPa on its edges as shown…
- GATE 2015 ME Set 2 · Q17A rod is subjected to a uni-axial load within linear elastic limit. When the change in the stress is 200…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.