GATE 2017 ME Set 1 · Question 43
A machine element has an ultimate strength () of , and endurance limit () of . The fatigue curve for the element on a log-log plot is shown below. If the element is to be designed for a finite life of cycles, the maximum amplitude of a completely reversed operating stress is ________ .
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The S-N curve between and cycles is linear on a vs plot, governed by the Basquin-type relation:
From the given curve:
- At cycles,
- At cycles,
The slope on the - plot is:
For a finite life of cycles:
Answer: 386.2
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2017 ME Set 2 · Q11A machine component made of a ductile material is subjected to a variable loading with σ = -50 MPa and σ =…
- GATE 2016 ME Set 2 · Q48In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical…
- GATE 2015 ME Set 1 · Q29Which one of the following is the most conservative fatigue failure criterion?
- GATE 2015 ME Set 3 · Q11For the given fluctuating fatigue load, the values of stress amplitude and stress ratio are respectively
- GATE 2014 ME Set 2 · Q20In a structure subjected to fatigue loading, the minimum and maximum stresses developed in a cycle are 200…
- GATE 2014 ME Set 3 · Q16A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.