GATE 2017 ME Set 2 · Question 20
Which one of the following statements is TRUE for the ultrasonic machining (USM) process?
- A
In USM, the tool vibrates at subsonic frequency.
- B
USM does not employ magnetostrictive transducer.
- C
USM is an excellent process for machining ductile materials.
- D
USM often uses a slurry comprising abrasive-particles and water.
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
In ultrasonic machining (USM):
1. The tool vibrates at an ultrasonic frequency (typically to , which is well above the human audible range, not subsonic), so option (A) is incorrect.
2. Transducers can be either piezoelectric or magnetostrictive; thus, magnetostrictive transducers are indeed employed, making option (B) incorrect.
3. USM removes material via micro-chipping/fracture caused by impacting abrasive grains, making it predominantly suitable for hard and brittle materials (e.g., glass, ceramics, quartz) rather than ductile materials, so option (C) is incorrect.
4. A continuous supply of abrasive slurry (commonly abrasive grains such as , , or mixed in water) is fed into the machining zone to enable abrasive action and flush away debris, making statement (D) correct.
Answer: (D) USM often uses a slurry comprising abrasive-particles and water.
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2016 ME Set 1 · Q33The non-traditional machining process that essentially requires vacuum is
- GATE 2016 ME Set 2 · Q35In an ultrasonic machining (USM) process, the material removal rate (MRR) is plotted as a function of the…
- GATE 2016 ME Set 2 · Q62The surface irregularities of electrodes used in an electrochemical machining (ECM) process are 3 μm and 6…
- GATE 2016 ME Set 3 · Q32In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that
- GATE 2015 ME Set 2 · Q31The primary mechanism of material removal in electrochemical machining (ECM) is
- GATE 2015 ME Set 2 · Q63A resistance-capacitance relaxation circuit is used in an electrical discharge machining process. The…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.