GATE 2018 ME Set 1 · Question 18
For an Oldham coupling used between two shafts, which among the following statements are correct?
I. Torsional load is transferred along shaft axis.
II. A velocity ratio of 1:2 between shafts is obtained without using gears.
III. Bending load is transferred transverse to shaft axis.
IV. Rotation is transferred along shaft axis.
- A
I and III
- B
I and IV
- C
II and III
- D
II and IV
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.8 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
An Oldham coupling is used to connect two parallel shafts whose axes are separated by a small lateral distance (eccentricity):
1. It transmits rotary motion and torque (torsional load) from the driving shaft to the driven shaft along the shaft axis, so statements I and IV are correct.
2. The angular velocity ratio between the driving and driven shafts is strictly at all times; hence, statement II is incorrect.
3. The central floating disc slides in the perpendicular grooves of the two flanges to accommodate lateral misalignment without transmitting bending loads across the shafts, so statement III is incorrect.
Therefore, only statements I and IV are correct.
Answer: (B)
Practise Planar Mechanisms, Mobility and Inversions
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Planar Mechanisms, Mobility and Inversions
- GATE 2018 ME Set 1 · Q30A four bar mechanism is made up of links of length 100, 200, 300 and 350 mm. If the 350 mm link is fixed,…
- GATE 2016 ME Set 3 · Q20The number of degrees of freedom in a planar mechanism having n links and j simple hinge joints is
- GATE 2015 ME Set 2 · Q19The number of degrees of freedom of the planetary gear train shown in the figure is
- GATE 2015 ME Set 3 · Q39The number of degrees of freedom of the linkage shown in the figure is
- GATE 2014 ME Set 1 · Q20For the given statements: I. Mating spur gear teeth is an example of higher pair II. A revolute joint is an…
- GATE 2014 ME Set 1 · Q47An offset slider-crank mechanism is shown in the figure at an instant. Conventionally, the Quick Return…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.