GATE 2018 ME Set 1 · Question 43
A tank open at the top with a water level of 1 m, as shown in the figure, has a hole at a height of 0.5 m. A free jet leaves horizontally from the smooth hole. The distance X (in m) where the jet strikes the floor is
- A
0.5
- B
1.0
- C
2.0
- D
4.0
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.33 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The head of water above the hole of height in a tank of total depth is:
By Torricelli's law, the horizontal exit velocity of the free jet is:
The vertical motion is governed by free fall from a height :
The horizontal distance traversed by the jet before striking the floor is:
Answer: (B) 1.0
Practise Fluid dynamics and flow measurement
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Fluid dynamics and flow measurement
- GATE 2018 ME Set 2 · Q44Air flows at the rate of 1.5 m3/s through a horizontal pipe with a gradually reducing cross-section as shown…
- GATE 2018 ME Set 2 · Q50A frictionless circular piston of area 10-2 m2 and mass 100 kg sinks into a cylindrical container of the…
- GATE 2017 ME Set 2 · Q39The arrangement shown in the figure measures the velocity V of a gas of density 1 kg/m3 flowing through a…
- GATE 2015 ME Set 1 · Q63Water (ρ = 1000 kg/m3) flows through a venturimeter with inlet diameter 80 mm and throat diameter 40 mm. The…
- GATE 2015 ME Set 3 · Q46A Prandtl tube (Pitot-static tube with C=1) is used to measure the velocity of water. The differential…
- GATE 2014 ME Set 3 · Q53A siphon is used to drain water from a large tank as shown in the figure below. Assume that the level of…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.