GATE 2018 ME Set 1 · Question 45
The maximum reduction in cross-sectional area per pass () of a cold wire drawing process is
where represents the strain hardening coefficient. For the case of a perfectly plastic material, is
- A
0.865
- B
0.826
- C
0.777
- D
0.632
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.35 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
For a cold wire drawing process, the maximum reduction in cross-sectional area per pass is given by:
For a perfectly plastic (non-strain-hardening) material, the strain hardening exponent is . Substituting this value into the expression:
Evaluating the exponential term:
Thus, the maximum reduction per pass for a perfectly plastic material is .
Answer: (D) 0.632
Practise Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
- GATE 2018 ME Set 2 · Q24Match the following products with the suitable manufacturing process | Product | Manufacturing Process | |…
- GATE 2018 ME Set 2 · Q57A steel wire is drawn from an initial diameter (di) of 10 mm to a final diameter (df) of 7.5 mm. The half…
- GATE 2017 ME Set 2 · Q25It is desired to make a product having T-shaped cross-section from a rectangular aluminium block. Which one…
- GATE 2015 ME Set 2 · Q59In a two-stage wire drawing operation, the fractional reduction (ratio of change in cross-sectional area to…
- GATE 2014 ME Set 2 · Q35With respect to metal working, match Group A with Group B: | Group A | Group B | | :--- | :--- | | P: Defect…
- GATE 2012 ME · Q2Match the following metal forming processes with their associated stresses in the workpiece. | Metal forming…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.