GATE 2018 ME Set 2 · Question 57
A steel wire is drawn from an initial diameter () of to a final diameter () of . The half cone angle () of the die is and the coefficient of friction () between the die and the wire is . The average of the initial and final yield stress is . The equation for drawing stress , (in MPa) is given as:
The drawing stress (in MPa) required to carry out this operation is ________ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.47 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The drawing stress is given by the formula:
Given data:
- ,
Evaluate the intermediate terms:
Substitute these values into the drawing stress equation:
Answer: 316.18
Practise Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
- GATE 2017 ME Set 2 · Q25It is desired to make a product having T-shaped cross-section from a rectangular aluminium block. Which one…
- GATE 2015 ME Set 2 · Q59In a two-stage wire drawing operation, the fractional reduction (ratio of change in cross-sectional area to…
- GATE 2014 ME Set 2 · Q35With respect to metal working, match Group A with Group B: | Group A | Group B | | :--- | :--- | | P: Defect…
- GATE 2012 ME · Q2Match the following metal forming processes with their associated stresses in the workpiece. | Metal forming…
- GATE 2025 ME · Q39Wire drawing operation is performed on a perfectly plastic metal without any strain hardening. Assuming no…
- GATE 2022 ME Set 2 · Q58A cylindrical billet of 100 mm diameter and 100 mm length is extruded by a direct extrusion process to…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.