GATE 2018 ME Set 2 · Question 62
A circular hole of diameter and depth of is machined by EDM process. The material removal rate (in ) is expressed as
where and the melting point of the material, . The time (in minutes) for machining this hole is ________ (correct to two decimal places)
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.52 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The volume of the cylindrical hole to be machined is:
The material removal rate (MRR) is given by:
Substituting the current and melting temperature :
The machining time is:
Answer: 7.14
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2017 ME Set 1 · Q22Match the processes with their characteristics. | Process | Characteristics | | :--- | :--- | | P:…
- GATE 2017 ME Set 2 · Q20Which one of the following statements is TRUE for the ultrasonic machining (USM) process?
- GATE 2016 ME Set 1 · Q33The non-traditional machining process that essentially requires vacuum is
- GATE 2016 ME Set 2 · Q35In an ultrasonic machining (USM) process, the material removal rate (MRR) is plotted as a function of the…
- GATE 2016 ME Set 2 · Q62The surface irregularities of electrodes used in an electrochemical machining (ECM) process are 3 μm and 6…
- GATE 2016 ME Set 3 · Q32In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.