GATE 2020 ME Set 2 · Question 21
Which one of the following statements about a phase diagram is INCORRECT?
- A
It indicates the temperature at which different phases start to melt
- B
Relative amount of different phases can be found under given equilibrium conditions
- C
It gives information on transformation rates
- D
Solid solubility limits are depicted by it
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.11 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
An equilibrium phase diagram graphically represents the phases present in an alloy system as a function of temperature, composition, and pressure under thermodynamic equilibrium:
1. Melting temperatures: The solidus and liquidus lines indicate the temperatures at which melting begins and completes (making (A) correct).
2. Phase amounts: By applying the lever rule along a tie-line in two-phase regions, the relative fractions of equilibrium phases can be calculated (making (B) correct).
3. Solubility limits: Solvus lines depict the limits of solid solubility (making (D) correct).
4. Kinetics: Phase diagrams contain no time dimension and provide no kinetic information regarding transformation rates or non-equilibrium phases. Rate information is obtained from Time-Temperature-Transformation (TTT) or Continuous Cooling Transformation (CCT) diagrams.
Therefore, statement (C) is incorrect.
Answer: (C) It gives information on transformation rates
Practise Phase Diagrams and Heat Treatment
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Phase Diagrams and Heat Treatment
- GATE 2019 ME Set 2 · Q24Hardenability of steel is a measure of
- GATE 2019 ME Set 2 · Q44The binary phase diagram of metals P and Q is shown in the figure. An alloy X containing 60% P and 40% Q (by…
- GATE 2018 ME Set 2 · Q22Denoting L as liquid and M as solid in a phase-diagram with the subscripts representing different phases, a…
- GATE 2017 ME Set 2 · Q22Given the atomic weight of Fe is 56 and that of C is 12, the weight percentage of carbon in cementite (…
- GATE 2016 ME Set 1 · Q30The "Jominy test" is used to find
- GATE 2016 ME Set 2 · Q31In the phase diagram shown in the figure, four samples of the same composition are heated to temperatures…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.