GATE 2020 ME Set 2 · Question 22
The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation with indicative values (I through VI) marking the various specifications whose definitions are listed below.
P: Maximum Waviness Height (mm); Q: Maximum Roughness Height (mm);
R: Minimum Roughness Height (mm); S: Maximum Waviness Width (mm);
T: Maximum Roughness Width (mm); U: Roughness Width Cutoff (mm).
The correct match between the specifications and the symbols (I to VI) is
- A
I-R, II-Q, III-P, IV-S, V-U, VI-T
- B
I-R, II-P, III-U, IV-S, V-T, VI-Q
- C
I-U, II-S, III-Q, IV-T, V-R, VI-P
- D
I-Q, II-U, III-R, IV-T, V-S, VI-P
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.12 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
In standard surface texture symbology (e.g., ANSI/ASME Y14.36M or ISO standards):
- Inside the check mark:
- Position specifies the maximum roughness height ( or ), which corresponds to .
- Position specifies the minimum roughness height, corresponding to .
- Above the horizontal extension line:
- Position indicates the maximum waviness height, corresponding to .
- Position indicates the maximum waviness width, corresponding to .
- Below or to the right of the extension line:
- Position specifies the roughness width cutoff (sampling length), corresponding to .
- Position specifies the maximum roughness width (spacing) or lay symbol, corresponding to .
Matching these positions yields:
Answer: (A) I-R, II-Q, III-P, IV-S, V-U, VI-T
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2020 ME Set 2 · Q42Two rollers of diameters D1 (in mm) and D2 (in mm) are used to measure the internal taper angle in the…
- GATE 2018 ME Set 1 · Q35The height (in mm) for a 125 mm sine bar to measure a taper of 27° 32' on a flat work piece is ________…
- GATE 2017 ME Set 1 · Q50Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to…
- GATE 2016 ME Set 3 · Q62Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light…
- GATE 2014 ME Set 1 · Q31Which one of the following instruments is widely used to check and calibrate geometric features of machine…
- GATE 2014 ME Set 2 · Q30The flatness of a machine bed can be measured using
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.