GATE 2021 ME Set 1 · Question 16
The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains corresponding to stress, respectively, are
- A
and
- B
and
- C
and
- D
and
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.6 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
From the given stress-strain curve:
- At the maximum applied stress of , the total strain is .
- Upon complete unloading along the elastic recovery path to zero stress, the permanent strain remaining in the material is the plastic strain:
The total strain is the sum of the elastic strain and plastic strain:
Therefore, the elastic strain recovered during unloading is:
Thus, the elastic and plastic strains corresponding to stress are and , respectively.
Answer: (B) and
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2019 ME Set 1 · Q35Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure.…
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
- GATE 2018 ME Set 1 · Q58The true stress (σ) - true strain ( ) diagram of a strain hardening material is shown in figure. First,…
- GATE 2018 ME Set 2 · Q56The true stress (in MPa) versus true strain relationship for a metal is given by σ = 1020 0.4. The…
- GATE 2017 ME Set 1 · Q25In the engineering stress-strain curve for mild steel, the Ultimate Tensile Strength (UTS) refers to
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.