GATE 2021 ME Set 1 · Question 17
In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to the plane of the generatrix as shown in figure, the surface generated is
- A
plane
- B
cylindrical
- C
spherical
- D
a surface of revolution
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.7 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
A machined surface is generated by the combination of two motions: the generatrix (the profile or generating curve) and the directrix (the guiding line along which the generatrix moves).
In the given figure, the generatrix is a circle (in a plane), and the directrix is a straight line perpendicular to the plane of the circle. When a circular generatrix translates along a straight directrix perpendicular to its plane, the envelope swept out in space is a cylindrical surface.
- A plane surface is produced when both the generatrix and directrix are straight lines.
- A surface of revolution is produced when a generatrix revolves about an axis in the same plane.
- A spherical surface requires a circular or semi-circular generatrix rotating about its diameter.
Answer: (B) cylindrical
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2021 ME Set 1 · Q18The correct sequence of machining operations to be performed to finish a large diameter through hole is
- GATE 2020 ME Set 1 · Q52A slot of 25 mm × 25 mm is to be milled in a workpiece of 300 mm length using a side and face milling cutter…
- GATE 2020 ME Set 2 · Q54There are two identical shaping machines S1 and S2. In machine S2, the width of the workpiece is increased…
- GATE 2019 ME Set 1 · Q25The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness…
- GATE 2019 ME Set 1 · Q62In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are 45° and 10°,…
- GATE 2019 ME Set 2 · Q26The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.