GATE 2021 ME Set 2 · Question 15
The size distribution of the powder particles used in Powder Metallurgy process can be determined by
- A
Laser scattering
- B
Laser reflection
- C
Laser absorption
- D
Laser penetration
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.5 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
In powder metallurgy, characterizing the particle size and particle size distribution (PSD) is essential for controlling compressibility, flowability, and sintering behavior.
A widely used modern technique for determining PSD across a broad range (from sub-micron to several millimeters) is laser scattering (also known as laser diffraction).
When a collimated laser beam illuminates a suspension of powder particles, the particles scatter light at angles inversely proportional to their size (governed by Fraunhofer diffraction and Mie scattering theories). By measuring the angular intensity distribution of the scattered light using an array of photodetectors, the particle size distribution is calculated.
Laser reflection, absorption, and penetration do not provide the angular intensity profiles necessary to resolve particle size distributions.
Answer: (A) Laser scattering
Practise Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy
- GATE 2018 ME Set 1 · Q45The maximum reduction in cross-sectional area per pass (R) of a cold wire drawing process is R = 1 -…
- GATE 2018 ME Set 2 · Q24Match the following products with the suitable manufacturing process | Product | Manufacturing Process | |…
- GATE 2018 ME Set 2 · Q57A steel wire is drawn from an initial diameter (di) of 10 mm to a final diameter (df) of 7.5 mm. The half…
- GATE 2017 ME Set 2 · Q25It is desired to make a product having T-shaped cross-section from a rectangular aluminium block. Which one…
- GATE 2015 ME Set 2 · Q59In a two-stage wire drawing operation, the fractional reduction (ratio of change in cross-sectional area to…
- GATE 2014 ME Set 2 · Q35With respect to metal working, match Group A with Group B: | Group A | Group B | | :--- | :--- | | P: Defect…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.