GATE 2022 ME Set 2 · Question 16
Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a stress-strain test on a metal specimen?
- A
Stress value where the stress-strain curve transitions from elastic to plastic behavior
- B
The maximum load attained divided by the original cross-sectional area
- C
The maximum load attained divided by the corresponding instantaneous cross-sectional area
- D
Stress where the specimen fractures
GATE 2022 · Mechanical Engineering · Set 2 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In a standard uniaxial tensile test on a metallic specimen, engineering stress is defined with respect to the initial (undeformed) dimensions of the test piece.
The engineering stress is given by:
where is the applied tensile load and is the original cross-sectional area of the gauge section.
The Ultimate Tensile Strength (UTS) corresponds to the highest point on the engineering stress-strain curve, representing the maximum load that the specimen can sustain before necking occurs:
- Option (A) defines the yield strength or proportional limit.
- Option (C) defines the true tensile strength at maximum load.
- Option (D) defines the fracture or rupture strength.
Answer: (B) The maximum load attained divided by the original cross-sectional area
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2021 ME Set 1 · Q16The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains…
- GATE 2019 ME Set 1 · Q35Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure.…
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
- GATE 2018 ME Set 1 · Q58The true stress (σ) - true strain ( ) diagram of a strain hardening material is shown in figure. First,…
- GATE 2018 ME Set 2 · Q56The true stress (in MPa) versus true strain relationship for a metal is given by σ = 1020 0.4. The…
Question from the official GATE 2022 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.