GATE 2012 ME · Question 32
A fillet welded joint is subjected to transverse loading as shown in the figure. Both legs of the fillets are of size and the weld length is . If the allowable shear stress of the weld is , considering the minimum throat area of the weld, the maximum allowable transverse load in is
- A
14.44
- B
17.92
- C
19.93
- D
22.16
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
For a fillet weld of leg size and length , the minimum throat thickness is:
Given , , and the allowable shear stress :
The throat area considered for the weld is:
The maximum allowable transverse load is:
Answer: (C)
Practise Welded Joints
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welded Joints
- GATE 2026 ME · Q21A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the…
- GATE 2025 ME · Q61Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the…
- GATE 2021 ME Set 1 · Q65A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown…
- GATE 2014 ME Set 4 · Q65A butt weld joint is developed on steel plates having yield and ultimate tensile strength of 500 MPa and 700…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.