GATE 2014 ME Set 4 · Question 65
A butt weld joint is developed on steel plates having yield and ultimate tensile strength of and , respectively. The thickness of the plates is and width is . Improper selection of welding parameters caused an undercut of depth along the weld. The maximum transverse tensile load (in ) carrying capacity of the developed weld joint is _______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.55 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The maximum load-carrying capacity of a tensile member is governed by the ultimate tensile strength () of the material and the minimum (critical) cross-sectional area available to resist the load.
Given:
- Plate thickness,
- Plate width,
- Depth of undercut,
- Yield strength,
- Ultimate tensile strength,
Due to the undercut along the length of the weld, the effective thickness of the joint is reduced to:
The effective cross-sectional area resisting the transverse tensile load is:
The maximum transverse tensile load carrying capacity corresponds to the ultimate strength:
Answer: 70
Practise Welded Joints
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welded Joints
- GATE 2012 ME · Q32A fillet welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets…
- GATE 2026 ME · Q21A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the…
- GATE 2025 ME · Q61Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the…
- GATE 2021 ME Set 1 · Q65A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.