GATE 2025 ME · Question 61
Two plates of thickness each are to be joined by a transverse fillet weld on one side and the resulting structure is loaded as shown in the figure below.
If the ultimate tensile strength of the weld material is and the factor of safety to be used is , the minimum length of the weld required to ensure that the weld does NOT fail is ________ (*rounded off to 2 decimal places*).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Given:
- Tensile load,
- Leg size of weld,
- Ultimate tensile strength,
- Factor of safety,
The permissible normal stress is:
The effective throat thickness of a fillet weld is:
Considering the transverse fillet weld designed on the basis of tensile stress:
If failure is assumed to occur in shear with maximum shear stress theory ():
Both design conventions are accepted by the official evaluation range.
Answer: 14.14
Practise Welded Joints
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welded Joints
- GATE 2021 ME Set 1 · Q65A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown…
- GATE 2014 ME Set 4 · Q65A butt weld joint is developed on steel plates having yield and ultimate tensile strength of 500 MPa and 700…
- GATE 2012 ME · Q32A fillet welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets…
- GATE 2026 ME · Q21A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.