GATE 2021 ME Set 1 · Question 65
A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown in figure. A vertical load of acts at free end of the beam.
Considering that the allowable shear stress in weld is , the minimum size (leg) of the weld required is ________ *(round off to one decimal place)*.
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.55 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The cantilever beam is subjected to a transverse load of at a distance of , and supported by two vertical fillet welds of length each, with weld leg size and throat thickness .
1. Direct shear stress:
2. Bending stress:
The bending moment at the weld is:
The second moment of area of the two welds about the horizontal neutral axis is:
The maximum bending stress at is:
3. Maximum shear stress:
Equating to the allowable shear stress :
Answer: 6.7
Practise Welded Joints
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welded Joints
- GATE 2014 ME Set 4 · Q65A butt weld joint is developed on steel plates having yield and ultimate tensile strength of 500 MPa and 700…
- GATE 2012 ME · Q32A fillet welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets…
- GATE 2026 ME · Q21A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the…
- GATE 2025 ME · Q61Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.