GATE 2014 ME Set 1 · Question 31
Which one of the following instruments is widely used to check and calibrate geometric features of machine tools during their assembly?
- A
Ultrasonic probe
- B
Coordinate Measuring Machine (CMM)
- C
Laser interferometer
- D
Vernier calipers
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.21 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
During the assembly and alignment of machine tools, geometric errors such as linear positioning errors, straightness, flatness, pitch, yaw, and squareness along the guideways must be accurately verified and calibrated over large travel lengths.
A laser interferometer provides extremely high precision (nanometer to sub-micron resolution) based on the wavelength of stabilized laser light. Its optical optics can be configured to measure linear displacement, angular deviations (pitch and yaw), and straightness over long distances, making it the industry standard for geometric calibration of machine tools.
- *Ultrasonic probes* are primarily used for non-destructive testing (flaw detection and thickness measurement).
- *Coordinate Measuring Machines (CMM)* are used to inspect finished components rather than aligning machine tools in situ.
- *Vernier calipers* lack the requisite precision and capability for comprehensive machine-tool alignment.
Answer: (C)
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2014 ME Set 2 · Q30The flatness of a machine bed can be measured using
- GATE 2014 ME Set 3 · Q63The diameter of a recessed ring was measured by using two spherical balls of diameter d2=60 mm and d1=40 mm…
- GATE 2013 ME · Q12A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3-wire method.…
- GATE 2026 ME · Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…
- GATE 2023 ME · Q54A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of…
- GATE 2023 ME · Q56An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.