GATE 2014 ME Set 3 · Question 63
The diameter of a recessed ring was measured by using two spherical balls of diameter and as shown in the figure.
The distance and . The diameter (, in ) of the ring gauge is ________
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The radii of the two balls are:
The distance between their centers along the line of contact is:
The vertical distance from the top reference surface to the center of ball 2 is:
The vertical distance to the center of ball 1 is:
The vertical distance between the centers is:
From the right-angled triangle , the horizontal separation is:
The diameter of the ring gauge is:
Answer: 93.3
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2013 ME · Q12A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3-wire method.…
- GATE 2026 ME · Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…
- GATE 2023 ME · Q54A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of…
- GATE 2023 ME · Q56An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge…
- GATE 2022 ME Set 2 · Q56The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the…
- GATE 2021 ME Set 1 · Q20Consider the surface roughness profile as shown in the figure. The center line average roughness (Ra, in μm)…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.