GATE 2026 ME · Question 33
A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus profilometer as shown in the figure below. A line AA parallel to the general lay of the trace is considered. The true heights from AA to the peaks and valleys (in ) in the trace are also shown in the figure (not to scale).
The ten-point height average in is
- A
2.90
- B
5.99
- C
4.57
- D
3.09
GATE 2026 · Mechanical Engineering · IIT Guwahati
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The ten-point height average roughness parameter, , is defined as the average distance between the five highest peaks and the five lowest valleys measured over the sampling length from a reference datum line parallel to the general lay of the trace (line AA):
From the given profile, the five highest peaks () are:
The five lowest valleys () are:
Substituting these values:
Answer: (C) 4.57
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2023 ME · Q54A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of…
- GATE 2023 ME · Q56An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge…
- GATE 2022 ME Set 2 · Q56The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the…
- GATE 2021 ME Set 1 · Q20Consider the surface roughness profile as shown in the figure. The center line average roughness (Ra, in μm)…
- GATE 2021 ME Set 2 · Q52A 76.2 mm gauge block is used under one end of a 254 mm sine bar with roll diameter of 25.4 mm. The height…
- GATE 2020 ME Set 2 · Q22The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation…
Question from the official GATE 2026 ME paper, IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.