GATE 2013 ME · Question 12
A metric thread of pitch and thread angle is inspected for its pitch diameter using 3-wire method. The diameter of the best size wire in is
- A
0.866
- B
1.000
- C
1.154
- D
2.000
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
In the three-wire method for measuring the effective (pitch) diameter of a screw thread, the best size wire contacts the thread flanks exactly at the pitch line.
The diameter of the best size wire is given by:
where is the pitch and is the included thread angle.
Given:
- Pitch,
- Thread angle,
Substituting the values:
Rounding off gives .
Answer: (C) 1.154
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2026 ME · Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…
- GATE 2023 ME · Q54A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of…
- GATE 2023 ME · Q56An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge…
- GATE 2022 ME Set 2 · Q56The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the…
- GATE 2021 ME Set 1 · Q20Consider the surface roughness profile as shown in the figure. The center line average roughness (Ra, in μm)…
- GATE 2021 ME Set 2 · Q52A 76.2 mm gauge block is used under one end of a 254 mm sine bar with roll diameter of 25.4 mm. The height…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.