GATE 2014 ME Set 1 · Question 32
The major difficulty during welding of aluminium is due to its
- A
high tendency of oxidation
- B
high thermal conductivity
- C
low melting point
- D
low density
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.22 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The primary challenge encountered when welding aluminium and its alloys is its extremely high chemical affinity for oxygen, which causes the spontaneous formation of a tenacious, refractory aluminium oxide () film on the surface.
The melting temperature of is approximately , whereas base aluminium melts at only about . This solid oxide skin prevents proper fusion, wetting, and coalescence of the molten weld pool unless it is actively removed using specialized flux or cathodic cleaning (such as in AC TIG welding).
Although aluminium's high thermal conductivity also requires higher heat inputs, the refractory oxide layer represents the most critical metallurgical impediment to achieving a sound weld.
Answer: (A)
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2014 ME Set 4 · Q30Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
- GATE 2024 ME · Q63In an arc welding process, the voltage and current are 30 V and 200 A, respectively. The cross-sectional…
- GATE 2022 ME Set 1 · Q57Two mild steel plates of similar thickness, in butt-joint configuration, are welded by gas tungsten arc…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.