GATE 2014 ME Set 2 · Question 64
A hole of diameter is to be drilled in a steel block of thickness. The drilling is performed at rotational speed of and feed rate of . The required approach and over run of the drill together is equal to the radius of drill. The drilling time (in minute) is
- A
1.00
- B
1.25
- C
1.50
- D
1.75
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The total travel length of the drill tool includes the workpiece thickness and the combined approach and overrun allowance :
Given:
- Block thickness,
- Drill diameter,
Therefore:
The feed speed of the drill is , where:
- Feed,
- Rotational speed,
The drilling time is:
Answer: (B) 1.25
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
- GATE 2022 ME Set 2 · Q54A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter (D) of…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.