GATE 2014 ME Set 3 · Question 30
A straight turning operation is carried out using a single point cutting tool on an AISI 1020 steel rod. The feed is and the depth of cut is . The tool has a side cutting edge angle of . The uncut chip thickness (in ) is ________
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.20 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The uncut chip thickness (undeformed chip thickness) in turning with a single-point tool is related to the feed and the side cutting edge angle (measured from the feed direction) by:
Given:
- Feed,
- Side cutting edge angle,
Substituting the given values:
Answer: 0.1
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2014 ME Set 3 · Q64Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool? P.…
- GATE 2014 ME Set 4 · Q33Better surface finish is obtained with a large rake angle because
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2012 ME · Q27Details pertaining to an orthogonal metal cutting process are given below. | | | |---|---| | Chip thickness…
- GATE 2026 ME · Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.