GATE 2014 ME Set 3 · Question 64
Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool?
P. Reduction in friction angle increases cutting force
Q. Reduction in friction angle decreases cutting force
R. Reduction in friction angle increases chip thickness
S. Reduction in friction angle decreases chip thickness
- A
P and R
- B
P and S
- C
Q and R
- D
Q and S
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
According to Merchant's analysis of orthogonal cutting, the shear plane angle is related to the rake angle and friction angle by:
1. Effect on Cutting Force: A reduction in friction angle causes the shear angle to increase. An increase in reduces the shear plane area (), which in turn lowers the shear force and the cutting force . Thus, statement Q is correct.
2. Effect on Chip Thickness: The chip thickness is given by:
As decreases, increases, leading to an increased chip thickness ratio , which means the chip thickness decreases. Thus, statement S is correct.
Therefore, statements Q and S are correct.
Answer: (D) Q and S
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2014 ME Set 4 · Q33Better surface finish is obtained with a large rake angle because
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2012 ME · Q27Details pertaining to an orthogonal metal cutting process are given below. | | | |---|---| | Chip thickness…
- GATE 2026 ME · Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip…
- GATE 2023 ME · Q44In an ideal orthogonal cutting experiment (see figure), the cutting speed V is 1 m/s, the rake angle of the…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.