GATE 2014 ME Set 4 · Question 45
A bolt of major diameter is required to clamp two steel plates. Cross sectional area of the threaded portion of the bolt is . The length of the threaded portion in grip is , while the length of the unthreaded portion in grip is . Young's modulus of material is . The effective stiffness (in ) of the bolt in the clamped zone is _______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.35 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The bolt consists of two sections in series within the grip: the unthreaded (shank) portion and the threaded portion. The cross-sectional area of the unthreaded shank is:
The area of the threaded portion is given as .
Given the lengths in grip and , and , the effective stiffness is:
Evaluating the flexibility terms:
Thus, the stiffness is:
Answer: 468.8
Practise Riveted & Bolted Joints
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Riveted & Bolted Joints
- GATE 2013 ME · Q48Common Data for Questions 48 and 49: A single riveted lap joint of two similar plates as shown in the figure…
- GATE 2013 ME · Q49Common Data for Questions 48 and 49: A single riveted lap joint of two similar plates as shown in the figure…
- GATE 2022 ME Set 1 · Q18A square threaded screw is used to lift a load W by applying a force F. Efficiency of square threaded screw…
- GATE 2022 ME Set 1 · Q40A bracket is attached to a vertical column by means of two identical rivets U and V separated by a distance…
- GATE 2020 ME Set 1 · Q49A rectangular steel bar of length 500 mm, width 100 mm, and thickness 15 mm is cantilevered to a 200 mm…
- GATE 2018 ME Set 2 · Q18Pre-tensioning of a bolted joint is used to
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.