GATE 2014 ME Set 4 · Question 64
A cast iron block of length is being shaped in a shaping machine with a depth of cut of , feed of and the tool principal cutting edge angle of . Number of cutting strokes per minute is 60. Using specific energy for cutting as , the average power consumption (in watt) is _______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The volume of material removed per cutting stroke depends on stroke length , feed per stroke , and depth of cut :
Given the frequency of strokes is , the average material removal rate (MRR) is:
The average power consumption is the product of specific cutting energy and the average MRR:
The tool principal cutting edge angle does not affect the total volume of metal removed per stroke.
Answer: 298
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
- GATE 2022 ME Set 2 · Q54A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter (D) of…
- GATE 2021 ME Set 1 · Q17In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to…
- GATE 2021 ME Set 1 · Q18The correct sequence of machining operations to be performed to finish a large diameter through hole is
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.