PARIXO GATE · ME Open the app

GATE 2012 ME · Question 4

1 markMultiple choiceManufacturing EngineeringPhase Diagrams and Heat Treatment

During *normalizing* process of steel, the specimen is heated

  1. A

    between the upper and lower critical temperature and cooled in still air.

  2. B

    above the upper critical temperature and cooled in furnace.

  3. C

    above the upper critical temperature and cooled in still air.

  4. D

    between the upper and lower critical temperature and cooled in furnace.

GATE 2012 · Mechanical Engineering · IIT Delhi

Answer
(C)

No official key survives for this paper; this is PARIXO AI's own answer, not official.

Worked solution

Normalizing is a heat treatment process used to refine the grain structure, relieve internal stresses, and improve mechanical properties of steel.

In normalizing:
1. The steel is heated to a temperature approximately to above the upper critical temperature ( for hypoeutectoid steels and for hypereutectoid steels) to completely transform it into austenite.
2. It is soaked at this temperature for a specified time and then cooled in still air at room temperature (unlike annealing, which is cooled slowly inside the furnace).

Therefore, the specimen is heated above the upper critical temperature and cooled in still air.

Answer: (C)

Practise Phase Diagrams and Heat Treatment

19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Phase Diagrams and Heat Treatment

Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.