GATE 2017 ME Set 2 · Question 54
During the turning of a -diameter steel bar at a spindle speed of , a tool life of is obtained. When the same bar is turned at , the tool life becomes . Assume that Taylor's tool life equation is valid. When the bar is turned at , the tool life (in minute) is approximately
- A
25
- B
32
- C
40
- D
50
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Taylor's tool life equation is given by:
Since the bar diameter is constant, the cutting speed is directly proportional to the spindle speed . Thus:
Given , , , and :
For :
Answer: (B) 32
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2016 ME Set 1 · Q60The tool life equation for HSS tool is VT0.14 f0.7 d0.4 = Constant. The tool life (T) of 30 min is obtained…
- GATE 2016 ME Set 3 · Q61In a single point turning operation with cemented carbide tool and steel work piece, it is found that the…
- GATE 2015 ME Set 1 · Q33Under certain cutting conditions, doubling the cutting speed reduces the tool life to (1/16 )th of the…
- GATE 2014 ME Set 3 · Q33Cutting tool is much harder than the workpiece. Yet the tool wears out during the tool-work interaction,…
- GATE 2013 ME · Q34Two cutting tools are being compared for a machining operation. The tool life equations are: aligned Carbide…
- GATE 2026 ME · Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200 RPM. If the…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.