GATE 2017 ME Set 2 · Question 53
A cylindrical pin of diameter is electroplated. Plating thickness is . Neglecting the gauge tolerance, the diameter (in , up to 3 decimal points accuracy) of the GO ring gauge to inspect the plated pin is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
A cylindrical pin is an external feature (shaft). A GO ring gauge is designed to verify the Maximum Material Condition (MMC) of the component.
The maximum material condition for a plated pin corresponds to the maximum pin diameter plus the maximum electroplating layer on both sides:
The maximum plating thickness is:
Since the plating is applied radially around the entire cylindrical surface, the total increase in diameter is :
Neglecting gauge tolerance, the size of the GO ring gauge is equal to the MMC size of the plated pin:
Answer: 29.03
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2016 ME Set 1 · Q35Match the following: | | | | | |---|---|---|---| | P. | Feeler gauge | I. | Radius of an object | | Q. |…
- GATE 2015 ME Set 1 · Q32Holes of diameter 25.0+0.020+0.040 mm are assembled interchangeably with the pins of diameter…
- GATE 2015 ME Set 1 · Q40In the assembly shown below, the part dimensions are: L1 = 22.0 0.01 mm, L2 = L3 = 10.0 0.005 mm. Assuming…
- GATE 2015 ME Set 2 · Q32Which one of the following statements is TRUE?
- GATE 2014 ME Set 1 · Q63For the given assembly: 25 H7/g8, match Group A with Group B | Group A | Group B | | :--- | :--- | | P. H |…
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.