GATE 2013 ME · Question 17
For a ductile material, toughness is a measure of
- A
resistance to scratching
- B
ability to absorb energy up to fracture
- C
ability to absorb energy till elastic limit
- D
resistance to indentation
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
Toughness of a material is defined as its capacity to absorb energy in the plastic deformation range up to fracture without rupturing. Mathematically, it is represented by the total area under the engineering stress-strain curve up to the fracture point.
Analyzing the other options:
- The ability to absorb energy within the elastic limit without permanent deformation is termed modulus of resilience (Option C).
- Resistance to scratching, abrasion, or localized plastic indentation defines hardness (Options A and D).
Answer: (B) ability to absorb energy up to fracture
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2022 ME Set 2 · Q16Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a…
- GATE 2021 ME Set 1 · Q16The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains…
- GATE 2019 ME Set 1 · Q35Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure.…
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
- GATE 2018 ME Set 1 · Q58The true stress (σ) - true strain ( ) diagram of a strain hardening material is shown in figure. First,…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.