GATE 2015 ME Set 2 · Question 60
The flow stress (in MPa) of a material is given by
where is true strain. The Young's modulus of elasticity of the material is . A block of thickness made of this material is compressed to thickness and then the load is removed. The final dimension of the block (in mm) is ________
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The true compressive strain imparted to the block is:
The flow stress at this strain is:
When the compressive load is removed, the material undergoes elastic recovery (springback). The recovered elastic strain is:
The increase in thickness due to elastic recovery is:
Thus, the final dimension of the block is:
Answer: 95.18
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2014 ME Set 3 · Q34The stress-strain curve for mild steel is shown in the figure given below. Choose the correct option…
- GATE 2013 ME · Q17For a ductile material, toughness is a measure of
- GATE 2022 ME Set 2 · Q16Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a…
- GATE 2021 ME Set 1 · Q16The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains…
- GATE 2019 ME Set 1 · Q35Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure.…
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.