GATE 2014 ME Set 3 · Question 34
The stress-strain curve for mild steel is shown in the figure given below. Choose the correct option referring to both figure and table.
| Point on the graph | Description of the point |
| :---: | :--- |
| P | 1. Upper Yield Point |
| Q | 2. Ultimate Tensile Strength |
| R | 3. Proportionality Limit |
| S | 4. Elastic Limit |
| T | 5. Lower Yield Point |
| U | 6. Failure |
- A
P-1, Q-2, R-3, S-4, T-5, U-6
- B
P-3, Q-1, R-4, S-2, T-6, U-5
- C
P-3, Q-4, R-1, S-5, T-2, U-6
- D
P-4, Q-1, R-5, S-2, T-3, U-6
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.24 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In the standard engineering stress-strain curve for mild steel under uniaxial tension, the characteristic points in order of increasing strain are:
1. : Limit of Proportionality (up to which Hooke's law holds strictly)
2. : Elastic Limit (maximum stress without permanent deformation)
3. : Upper Yield Point (onset of plastic flow)
4. : Lower Yield Point (steady plastic flow at lower stress)
5. : Ultimate Tensile Strength (maximum engineering stress sustained)
6. : Fracture/Failure Point (breaking point)
Matching these gives: P-3, Q-4, R-1, S-5, T-2, U-6.
Answer: (C) P-3, Q-4, R-1, S-5, T-2, U-6
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2013 ME · Q17For a ductile material, toughness is a measure of
- GATE 2022 ME Set 2 · Q16Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a…
- GATE 2021 ME Set 1 · Q16The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains…
- GATE 2019 ME Set 1 · Q35Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure.…
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.