GATE 2018 ME Set 2 · Question 58
Following data correspond to an orthogonal turning of a diameter rod on a lathe.
Rake angle: ; Uncut chip thickness: ; nominal chip thickness after the cut: . The shear angle (in degrees) for this process is ________ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.48 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The chip thickness ratio is defined as the ratio of uncut chip thickness () to chip thickness after cut ():
The shear angle is related to and the rake angle by:
Substituting the given values:
Taking the inverse tangent:
Answer: 23.32
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2017 ME Set 2 · Q55In an orthogonal machining with a tool of 9° orthogonal rake angle, the uncut chip thickness is 0.2 mm. The…
- GATE 2016 ME Set 1 · Q34In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and…
- GATE 2016 ME Set 3 · Q59For an orthogonal cutting operation, tool material is HSS, rake angle is 22°, chip thickness is 0.8 mm,…
- GATE 2015 ME Set 1 · Q45An orthogonal turning operation is carried out under the following conditions: rake angle = 5°; spindle…
- GATE 2015 ME Set 2 · Q62A single point cutting tool with 0° rake angle is used in an orthogonal machining process. At a cutting…
- GATE 2015 ME Set 3 · Q44Orthogonal turning of a mild steel tube with a tool of rake angle 10° is carried out at a feed of 0.14…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.