PARIXO GATE · ME Open the app

GATE 2025 ME · Question 39

2 marksMultiple choiceManufacturing EngineeringBulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy

Wire drawing operation is performed on a perfectly plastic metal without any strain hardening. Assuming no friction and no redundant work, the maximum possible percentage reduction in area in a single pass is closest to

  1. A

    51.2

  2. B

    63.2

  3. C

    75.0

  4. D

    93.2

GATE 2025 · Mechanical Engineering · IIT Roorkee

Answer
(B)

From the official answer key published by IIT Roorkee.

Worked solution

In an ideal wire drawing operation (neglecting friction and redundant deformation) of a perfectly plastic material with yield stress , the drawing stress is given by:

where is the initial cross-sectional area and is the final cross-sectional area.

To prevent plastic deformation or necking of the drawn wire at the die exit, the drawing stress must not exceed the yield stress of the material:

The maximum possible fraction of area reduction is:

Expressed as a percentage:

Answer: (B) 63.2

Practise Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy

10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Bulk Deformation II: Extrusion, Wire Drawing and Powder Metallurgy

Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.