GATE 2019 ME Set 1 · Question 62
In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are and , respectively. The feed during cylindrical turning is . The center line average surface roughness (in , round off to one decimal place) of the generated surface is____
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.52 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For a single-point turning tool without nose radius (sharp tool), the peak-to-valley surface roughness is given by:
where:
- is the feed,
- is the side cutting edge angle,
- is the end cutting edge angle.
Substituting the angles:
For ideal triangular profile asperities generated by a sharp tool, the center line average (CLA) roughness is:
Rounding off to one decimal place gives (or ).
Answer: 3.7
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2019 ME Set 2 · Q26The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative…
- GATE 2019 ME Set 2 · Q63A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm,…
- GATE 2018 ME Set 2 · Q25Feed rate in slab milling operation is equal to
- GATE 2018 ME Set 2 · Q27The preferred option for holding an odd-shaped workpiece in a centre lathe is
- GATE 2017 ME Set 1 · Q24Metric thread of 0.8 mm pitch is to be cut on a lathe. Pitch of the lead screw is 1.5 mm. If the spindle…
- GATE 2017 ME Set 1 · Q53A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.