GATE 2018 ME Set 2 · Question 25
Feed rate in slab milling operation is equal to
- A
rotation per minute (rpm)
- B
product of rpm and number of teeth in the cutter
- C
product of rpm, feed per tooth and number of teeth in the cutter
- D
product of rpm, feed per tooth and number of teeth in contact
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.15 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
In a slab milling operation, the table feed rate (or linear feed rate) (typically in ) is the distance the workpiece advances per unit time. It depends on:
- : feed per tooth (advance per tooth engagement, ),
- : total number of teeth in the milling cutter,
- : rotational speed of the cutter in revolutions per minute ().
The table feed rate is given by:
Thus, the feed rate is the product of rpm, feed per tooth, and the total number of teeth in the cutter.
- Option (A) is simply the rotational speed.
- Option (B) represents the tooth engagement frequency (teeth passing per minute), not distance per minute.
- Option (D) incorrectly considers only the teeth in contact instead of the full set of teeth rotating per minute.
Answer: (C) product of rpm, feed per tooth and number of teeth in the cutter
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2018 ME Set 2 · Q27The preferred option for holding an odd-shaped workpiece in a centre lathe is
- GATE 2017 ME Set 1 · Q24Metric thread of 0.8 mm pitch is to be cut on a lathe. Pitch of the lead screw is 1.5 mm. If the spindle…
- GATE 2017 ME Set 1 · Q53A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table…
- GATE 2016 ME Set 2 · Q34The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is…
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.