GATE 2018 ME Set 2 · Question 27
1 markMultiple choiceManufacturing EngineeringBasic Machine Tools and Operations
The preferred option for holding an odd-shaped workpiece in a centre lathe is
- A
live and dead centres
- B
three jaw chuck
- C
lathe dog
- D
four jaw chuck
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.17 in the ME section
Answer
(D)
From the official answer key published by IIT Guwahati.
Worked solution
In a centre lathe, different work-holding devices are chosen based on the symmetry and geometry of the workpiece:
- Four-jaw chuck (Independent chuck): Each of the four jaws moves independently in its own radial slot via a separate screw. This independent motion allows workpieces of irregular, asymmetrical, or odd shapes (e.g., rectangular, hexagonal, or eccentric components) to be clamped securely and centered accurately.
- Three-jaw chuck (Universal/Self-centering chuck): All three jaws move simultaneously via a scroll plate, which is designed exclusively for regular cylindrical or hexagonal workpieces.
- Live and dead centres: Used along with a lathe dog to hold long cylindrical shafts between centres.
Hence, the four-jaw chuck is the preferred option for odd-shaped workpieces.
Answer: (D) four jaw chuck
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2017 ME Set 1 · Q24Metric thread of 0.8 mm pitch is to be cut on a lathe. Pitch of the lead screw is 1.5 mm. If the spindle…
- GATE 2017 ME Set 1 · Q53A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table…
- GATE 2016 ME Set 2 · Q34The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is…
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.