GATE 2017 ME Set 1 · Question 53
A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table feed are set at 2 mm and 18 mm/minute, respectively. Considering the approach and the over travel of the cutter to be same, the minimum estimated machining time per pass is ________ minutes.
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For a slab milling operation, the cutter approach distance is given by:
where the cutter diameter is and depth of cut is .
Since the over-travel is equal to the approach distance:
The total cutter travel per pass is:
Given the table feed , the minimum estimated machining time per pass is:
Answer: 12
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2016 ME Set 2 · Q34The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is…
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.