GATE 2017 ME Set 1 · Question 24
1 markNumerical answerManufacturing EngineeringBasic Machine Tools and Operations
Metric thread of pitch is to be cut on a lathe. Pitch of the lead screw is . If the spindle rotates at , the speed of rotation of the lead screw (rpm) will be _________
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
800
From the official answer key published by IIT Roorkee.
Worked solution
In a thread cutting operation on a lathe, the linear feed rate of the tool per minute must match between the carriage drive (via the lead screw) and the spindle rotation:
where:
- is the rotational speed of the lead screw in rpm,
- is the pitch of the lead screw,
- is the spindle speed,
- is the pitch of the thread to be cut.
Rearranging to solve for :
Substitute the given parameters:
Answer: 800
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2017 ME Set 1 · Q53A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table…
- GATE 2016 ME Set 2 · Q34The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is…
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.