GATE 2019 ME Set 2 · Question 63
A through hole is drilled in an aluminum alloy plate of thickness with a drill bit of diameter , at a feed of and a spindle speed of . If the specific energy required for cutting this material is , the power required for drilling is _______ (round off to two decimal places).
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
The material removal rate () in drilling is given by:
where:
- Drill diameter
- Feed
- Spindle speed
The feed rate in is:
Thus, the material removal rate is:
The cutting power required is the product of specific energy () and :
Given :
Answer: 274.89
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2018 ME Set 2 · Q25Feed rate in slab milling operation is equal to
- GATE 2018 ME Set 2 · Q27The preferred option for holding an odd-shaped workpiece in a centre lathe is
- GATE 2017 ME Set 1 · Q24Metric thread of 0.8 mm pitch is to be cut on a lathe. Pitch of the lead screw is 1.5 mm. If the spindle…
- GATE 2017 ME Set 1 · Q53A block of length 200 mm is machined by a slab milling cutter 34 mm in diameter. The depth of cut and table…
- GATE 2016 ME Set 2 · Q34The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is…
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.