GATE 2019 ME Set 2 · Question 27
1 markMultiple choiceManufacturing EngineeringLimits, Fits, Tolerances and Gauge Design
The most common limit gage used for inspecting the hole diameter is
- A
Snap gage
- B
Ring gage
- C
Plug gage
- D
Master gage
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.17 in the ME section
Answer
(C)
From the official answer key published by IIT Madras.
Worked solution
Limit gages are inspection tools used to check whether a manufactured component lies within specified tolerance limits according to Taylor's principle:
- Plug gage: Designed with GO and NO-GO cylindrical ends, it is the most common limit gage used for inspecting internal dimensions such as hole diameters.
- Snap gage: Primarily used for inspecting external linear dimensions, such as the outside diameter of shafts or overall thickness.
- Ring gage: Used to check external cylindrical features, such as round shafts.
- Master gage: A high-precision reference standard used to calibrate other working gages rather than directly inspecting workpieces in production.
Therefore, the plug gage is used to inspect hole diameters.
Answer: (C) Plug gage
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
- GATE 2017 ME Set 2 · Q53A cylindrical pin of 25+0.020+0.010 mm diameter is electroplated. Plating thickness is 2.0 0.005 mm.…
- GATE 2016 ME Set 1 · Q35Match the following: | | | | | |---|---|---|---| | P. | Feeler gauge | I. | Radius of an object | | Q. |…
- GATE 2015 ME Set 1 · Q32Holes of diameter 25.0+0.020+0.040 mm are assembled interchangeably with the pins of diameter…
- GATE 2015 ME Set 1 · Q40In the assembly shown below, the part dimensions are: L1 = 22.0 0.01 mm, L2 = L3 = 10.0 0.005 mm. Assuming…
- GATE 2015 ME Set 2 · Q32Which one of the following statements is TRUE?
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.